Raymarine EV-200 Power Hydraulic Evolution Autopilot with Type 1 Hydraulic Pump

Raymarine EV-200 Power Hydraulic Evolution Autopilot with Type 1 Hydraulic Pump

EV-200 Power Hydraulic Evolution Autopilot

Features:

A complete autopilot-in-a-box

Evolution Ai for superior performance

No calibration required

Includes Type 1 Hydraulic Drive Unit

SeaTalkng Network Compatible

ACU-200 auxiliary power to SeaTalkng network

Includes p70R Autopilot Controller

Includes:

EV-1 Sensor Core

p70R Autopilot Control Head

ACU-200 Actuator Control Unit (Includes the M81105 Rotary Rudder Reference)

Type 1 Hydraulic Pump

Evolution Cabling Kit

EV Unit O-Ring Pack (set of 2)

Wall Mounting Bracket

The EV Sensor Core
At the center of every Evolution system is the intelligent EV sensor core, a 9-axis sensor that monitors vessel motion in all three dimensions. The innovative EV sensor core combines advanced solid-state sensors with the Evolution autopilot processor into a single easy-toinstall housing.

Mount the EV sensor core above or below decks, the rugged enclosure is fully sealed and built to IPX6 and IPX7 waterproofing and submersion standards.

The EV-1 is designed for Evolution mechanical and hydraulic autopilot systems. SeaTalkng networking enables a single cable connection for power and data to the Evolution ACU (actuator control unit) and extended SeaTalkngand NMEA2000 networks.

Features:

Precision monitoring of heading, pitch, roll, and yaw allowing the autopilot to evolve instantly as sea conditions and vessel dynamics change

Flexible installation options

Mount above or below deck

Simple SeaTalkng connectivity to the control head and ACU

Solid state sensor technology delivers dynamic accuracy to within 2 degrees in all conditions

Fast and reliable heading data for MARPA, radar overlay, and heading modes on Raymarine multifunction displays

p70R Autopilot Control Head
The p70R has a convenient rotary control knob and support for multiple autopilot modes including Auto, standby, trolling patterns, and track mode from your GPS or chartplotter.

Features:

LightHouse user interface is simple and quick to use

Wide 160° viewing angles

Start up wizard helps you configure the pilot quickly and easily

Anti-reflective coating for improved visibility in bright sunlight

Low power - typically 132mA/1.6W - 27% less than ST70 at x4 measured brightness

Supported autopilot modes: Auto; Standby; Pattern; Track; Wind Vane; Power Steer and Jog Steer

Simple system and group dimming/illumination

Support for multiple data sources

SeaTalkng/NMEA2000 and SeaTalk1 connectivity (no bridging required)

ACU-200 Autopilot Control Unit (ACU)
The rugged ACU (Actuator Control Unit) delivers reliable autopilot drive power and also provides power to the SeaTalkng bus. Choose the ACU that fits your steering system type.

Type 1 Hydraulic Pump
The reversing 12V hydraulic pump is for use with steering systems equipped with 4.914 cubic inch (80cc - 230cc) hydraulic steering rams. The Type 1 hydraulic drive is compatible with both S1/S1G and S2/S2G corepacks.

Evolution Cabling Kit

1 x SeaTalkng Power Cable (0.4m)

1 x SeaTalkng Backbone Cable (5m)

1 x SeaTalkng Spur Cable (0.4m)

1 x SeaTalkng 5-way Connector Block

2 x SeaTalkng T-piece Connector

2 x SeaTalkng Terminator